How do I mount the halo inside of the headlight?
There’s a few ways to go about this:
- Use the 3M adhesive tape found on the backside of your halo ring, be sure to prep the area by cleaning the surface with the alcohol pre-pad provided. Let is dry and before applying the halos, measure the area you wish to apply the strips to before doing so.
- Take covers off in front of the vehicle
- Slide each LED Strip into each headlight space
- Place the 4 wire sets in place (by each led strip ) and plug them into led strip
- Wire all of the wire sets to the control box included into kit
- Ground the control box to the car and plug fuse into the fuse box (use car charging port if not using ground method)
- Take tape off back of led strip and stick in place
- Check out video install below:
Install video by: Don 392